CMMG MK9 9mm Stripped Lower


CMMG MK9 9mm Stripped Lower

CMMG MK9 9mm Stripped Lower

E-mail this product to a friend E-mail this product to a friend


Previous  Up  Next 

CMMG, Inc MK-9 semi-auto dedicated 9mm AR15 stripped lower receiver. The integral magazine well is compatible with Colt and Uzi style magazines. Lower receivers use Mil-Spec, .250 diameter take-down pins and .154 diameter fire control pins. Aircraft grade 7075 T6 aluminum billet is hard coat anodized to Mil-Spec. Receivers are RDIAS/RLL compatible. Lower includes the 9mm specific feed ramp, bolt catch and ejector already installed.

NOTICE: As required by federal law, this item may only be sent to a dealer with a valid Federal Firearms License.

Federal law requires that you be 21 years or age or older to purchase a stripped receiver or frame.  If a frame or receiver can only be made into a long gun (rifle or shotgun), it is still a frame or receiver not a handgun or long gun.  However, they still are "firearms" by definition, and subject to the same GCA limitations as any other firearms.  See Section 921(a)(3)(b).  18 U.S.C. Section 922(b)(1) makes it unlawful for a licensee to sell any firearm other than a shotgun or rifle to any person under the age of 21.

Out of stock
as of 05/21/2013 5:07AM PST

SKU:CMMG-MK9LOWER
Price: $219.00 


Enter your email address below to receive
an email when the product is back in stock:

Quantity:  




ASC 10rd 9mm magazine
ASC 10rd 9mm magazine
Out of stock
Yankee Hill Machine EZ-Pull Takedown Pin Set
Yankee Hill Machine EZ-Pull Takedown Pin Set
In stock
RRA 9mm Buffer
RRA 9mm Buffer
Out of stock



Rating: (4.00)   # of Ratings: 1   (Only registered customers can rate)

(Only registered customers can rate)

1 - Terrible
2 - Bad
3 - OK
4 - Good
5 - Great
0% 50% 100%

Sort:

Showing comments 1-1 of 1
1. David on 8/23/2010, said:

Purchased one of these several months ago. Had a small problem with the Bolt Hold Open Latch. Drove out the latch pin and used a dremel to take a small amount off the back side of the lower ear. Voila, No more problem. Thi sallowed the Latch to rise up a little more to catch the Bolt.
Was this comment helpful? yes no   (2 people found this comment helpful, 0 did not)
Showing comments 1-1 of 1