ARMaglock AR-10 Fixed Magazine Lock & Release Kit

Regular Price: $52.90
Our Price: $49.99
Out of stock
as of 05/11/2021 5:09AM CST

Store Inventory
Available OnlineOut of stock
Fountain Valley, CAOut of stock
The Colony, TXOut of stock
Enter your email address below to receive an email when the product is back in stock:

Inter-Store Transfer

If this item is out of stock at your local RifleGear but available at our other location, no problem. Just place your order and select In-Store Pickup as the shipping method. As long as the item is legal in your location, we will transfer the item for you. You will be notified by e-mail when your item arrives.

The ARMagLock renders your MIL-SPEC AR-10 a "fixed magazine" firearm while installed. By installing an ARMagLock you no longer own a "detachable" magazine firearm which is classified as an "assault weapon". This AR-10/.308 kit does not require the need of the Wide Receiver Adapter Kit, the spacer and longer screw are already included.

This kit does come with a rear take-down pin but, because .308 lower receivers are so differing in their pin diameter sizing, may only fits about 50% of the firearms in the market. There is NO guarantee the pin will fit your lower receiver.

The ARMagLock allows the shooter to re-insert a magazine while the upper and lowers receivers (the action) are closed or open, allowing for SIGNIFICANTLY faster magazine changes. The competitors’ products ONLY allow the shooter to re-insert a magazine while the action is in the open state, slowing you down CONSIDERABLY.  Also allows you to have the ejection port cover open or closed when closing the action, the competition only allows this with the port door closed, causing even slower operation. This product does not scratch your upper receiver with an adjustment screw like competition does. Last but certainly not least, it also has finger knurling for excellent grip in any and all weather conditions, in addition to coming with the knurled grip rear take-down pin and accompanying split ring for quick pull operation. 

ARMagLock allows California, New York, Connecticut, Maryland, New Jersey and other states (and other local municipalities such as Cook County Illinois) AR-15 owners to comply with existing and proposed fixed magazine laws, potentially avoiding registration within their respective states.

*Some fitting/modifications may be required for install.
*Does not work on lowers with ambidextrous bolt catch/release assemblies

Note: It is required that you drill out the head of the allen bolt after installation so the modification is permanent. We also recommend using red threadlocker on the allen bolt.

*This product has not been approved by the CA DOJ, Police(state or local) or Attorney General. Know your local and state laws and firearm regulations.

Customer Reviews

(3.00)stars out of 5
# of Ratings: 2
1. on 12/4/2017, said:
3 stars out of 5
It works but not flawless , it was designed for AR15. For the device to work with AR10, you have to use the small sleeve provided which will make the operation less than ideal. The sleeve needs to be trimmed as to the right length and will snag on use. It would be nice if they actually made one specifically for the AR10.
Was this comment helpful?
(2 people found this comment helpful, 1 did not)
2. on 1/14/2017, said:
3 stars out of 5
Be aware that the rear takedown pin the manufacturer supplies is not the correct pin. They gave me pins too small for my .308 receiver. They are likely AR 15 pins which is not correct. Plus the pins are made out of cheap aluminum not steel. The detent holes are too deep and they are difficult to pull out. So while the release is okay the rear takedown pin is poor.
Was this comment helpful?
(4 people found this comment helpful, 0 did not)
Showing comments 1-2 of 2